Preparations

Exaktosil Silicone Putty A & B;

• The addition-linking kneading silicone.
• Particularly soft kneading silicones for matrices.
• For the utmost precision.

540 0102 4 – Comp. A & B 1,300 grams each

540 0102 5 – Comp. A & B 7,500 grams each

Material Saftey Data Sheet

The Exaktosil Plus kneading silicone is mixed from two components, A & B in a ratio of 1:1.	Homogeneous processing of the two components is ensured by kneading them for approx. 30 sec. until a uniform colour.	Exaktosil kneading silicones have a particularly soft consistency for precise adaptation of the material.	The fine reproduction of details and high stability of the Exaktosil kneading silicones provide accurate matrices.

Exaktosil Silicone Putty C, Assortment

The condensation-linking silicone.
The economic alternative

540 0102 9 – Assortment; 1,250 base material, 50 gram hardener paste.
540 0103 0 – Assortment; 7,500 base material, 6 x 50 gram hardener pastes.

Material Saftey Data Sheet

A measuring spoon of Exaktosil C kneading silicone is mixed with 3 cm. of hardener paste.	Homogenous process of the two components is ensured by kneading them for approx. 30 secs. for homogenous colour.	Exaktosil kneading silicones have a particularly soft consistency for precise adaptation of the material.	The fine reproduction of details and high stability of the Exaktosil kneading silicones provide accurate matrices.

Exakto Form

Exakto-Form Insulating Liquid

Exakto-Form Kit – A model resin for accurate reproduction and maximum edge stability.
Order No: 52000280 – 6 x 50 g. each of Component A & B.

Material Saftey Data Sheet Component A
Material Saftey Data Sheet Component B

Order Number: 52000210

Material Saftey Data Sheet

Prior to mixing, each component must be stirred so that a homogeneous mixture is obtained.	Add component A to component B; empty tin completely.	Mix Exakto-Form approximately 30 seconds until a uniform colour is obtained.	Two twins of Exakto- Form are sufficient to produce 2 – 3 complete dental arches.	The material can be removed after 30 mins. Final hardness is achieved after 10 mins. Then the model can be trimmed.
If a base for the model is to be made with Exakto-Form, the model must be previous insulated with Insulating Liquid.	Due to is high edge stability, Exakto-Form is perfectly suitable for precision fit bridge and crown work.	Any technique can be used for sawing Exakto-Form models. Here we are using our Giflex.	If smaller quantities are required, fill component A and B into a separate syringe.	Fill equal quantities of Exakto-Form into a silicone beaker (approx. 2 ml for one die) and mix to obtain a homogeneous material.

Investment Marker

Investment Pen; 330 0115 0 Material Saftey Data Sheet	All the necessary information is recorded.	At 1100 Deg. Celsius information remains readable.