|
|
|
|
Since the non-threaded section is in the inner coping, no micro-movements can be transferred. This guarantees that the threaded rod will not loose inadvertently.
 |
 |
 |
| The different sizes can be used for a wide range of applications with implants and bridges etc.. | In this case a superstructure is to be retained with a screw. The abutment should be waxed up using standard procedures. | Once the abutment has been cast, it should be milled and polished.
|
 |
 |
 |
| A centering drill is used to create a purchase point in the correct
position.
|
The correct size of Multidrill is used to drill a hole at the correct angle for the threaded rod. It is absolutely essential that Bredent milling/drilling oil is used. | Screw the threaded rod into the threaded sleeve. Both the pin and the hexagonal socket can be reduced as required. |
 |
 |
 |
| Coat the threaded rod and sleeve with Pi-Ku-Plast,
Order No, 54000176.
|
Pi-Ku-Plast guarantees optimum strength for continued processing.
|
Screw a retention screw coated with colloidal graphite into the threaded sleeve to retain it in the investment material. |
